🦡 Power Window Switch Problem

open, press the power window switch to fully open the window. Pull the power switch up to close the window. Continue holding the switch up for four seconds after the glass stops at the fully closed position. Next, confirm that the Anti-Pinch feature is working. Fully open the window. Hold a piece of wood or plastic at the top of the Check for power to the switch (key on), no power to switch check plug and wires for corrosion/ damage. If you have power to the switch, check the switch (contacts in switch may be worn/corroded/damaged. If switch is working probable bad window motor/binding regulator, test the power window motor/regulator,replace if weak,damaged or not functioning. Start your Liberty. Close all windows and doors. Open the window by pressing and holding the window control switch. When the window is fully open, keep the switch pressed for a few seconds. Release the switch, then press it again and hold it for a few seconds. Close the window by lifting and holding the window control switch. The window motor harness has power and ground and 4 more wires how to bypass to check motor Mechanic's Assistant: Anything else you want the mechanic to know before I connect you? Switch is not the problem Tryed new one and new motor but not working Reset Procedure 2. If the above reset instructions do not work for your PT Cruiser, then this alternate method may work. Start your PT Cruiser. Close all windows and doors. Open the window by pressing and holding the window control switch. When the window is fully open, keep the switch pressed for a few seconds. The affected side is the passenger window. First, I noticed the passenger up/down switch was not working. However the master controls (located on the driver side) was able to raise and lower the passenger window. About 10 mins later, the passenger side UP worked briefly (but DOWN did not). Then, master control did not work. Toyota Corolla windows don’t work or stay off track if there’s a fuse, battery, or electrical problem. You can fix it by replacing the fuse or unscrewing the door panel, and aligning the window with the track. Reset power windows by holding the switch up for about five to ten seconds. The power side view mirrors and master window control are all on the same 7.5 amp fuse located in the fuse box under the hood. Fuse nor the master switch was the issue. Mechanic believes their is corrosion in the fuse panel. Recommend replacing to correct issue. Repair estimate was about $800.00. Intermittent passenger window problem. You can use a DMM to make sure power is there. If it is, you've got a mechanical problem. As your is an '89, you probably have a hex key in your toolkit that fits into the window gear that's hidden behind the (upper) door speaker. Remove the speaker grille to find it. .

power window switch problem